Add Comment

Here you can comment on the following topic by using the form below it.

Mount you material to the wasteboard
Manually move the router to the left front corner of the workpiece
Check/adjust the X axis so that it is parallel to the front of the machine
Use the Z knob and a piece of paper to adjust the Z axis
Turn on the X-Carve "CNC" switch to set the project origin (X,Y,Z 0)
Position the dust shoe and tighten the top knob
Click the Carve button
Turn on the "Spindle" switch when asked if the router is on
Turn off the "Spindle" switch for tool changes (NOT the CNC switch)
Select the appropriate Easel Workpiece
Only move the X and Y axes in custom increments, e.g. 100mm/4.0"
Raise Z as needed and change the tool
Use the same custom increments to return X and Y to the corner of the material
Use increasingly smaller Z increments to get the new tool down to the material
Click the Carve button and, when asked, select use New position (NOT Last position)
Turn on the "Spindle" switch when asked if the router is on

Form